Owner-produced parts, manuals, blow by and more. Send your questions to [email protected] for a chance to get on the show. Join the world's largest aviation community at aopa.org/join Full episode notes below: Daniel wonders whether it's possible to make your own parts. The hosts explain that the standard is that owner-produced parts must be at least as good as the original, meaning they can be even better. To achieve that standard they recommend going to a machine shop or good mechanic who can reverse engineer it. Paul said Textron is really good about sharing information, and sometimes even basic drawings, especially if they no longer produce the part. Key to this is that the mechanic must be ok with it, and supportive. Mike further points out that a minor alteration only needs acceptable data, while a major repair requires approved data. Given that this is a minor repair, Daniel can even use acceptable data or methods. Jerry is an IA who is wondering how to deal with manuals. This i
Engines fail when they're new, not old. Plus, leaning with carb heat, questions to ask as a renter, and Cirrus cylinder cracking. Email [email protected] for a chance to get on the show. Join the world's largest aviation community at aopa.org/join Full notes below: Kevin is looking to rent an airplane from a private owner and he's looking for opportunities on Facebook. When he goes to see the airplane and meet the owner, Kevin is wondering what he should ask. Paul suggests staring with the logbooks and looking for the annual inspection sign off with a note that the ADs have been complied with. Colleen says to start with the books and then go through a thorough pre-flight. If the owner balks at repairs that you consider essential, she suggests walking. The hosts debate the importance of how many people fly the airplane, but settle on the fact that what really matters is a standard squawk sheet. Alan is concerned about the new Cirrus service bulletin that describes cylinder cracks on Con